Miter Saw
Band Saw
Scroll Saw
General Lab
100
Hands or fingers should never come closer than ___________ to the rotating blade.
What is 4 (four) inches
100
The best time to remove scrap material from the band saw is ___________.
When the saw stops
100
True or False: Always leave the saw with the light off and the speed all the way down
True
100
A student is permitted to leave the laboratory only ________.
With the teacher's permission
200
What personal protective equipment should be worn when operating the motorized miter saw? (List 2 equipment)
Safety glasses, Hearing protection
200
If the blade breaks on the band saw, shut off the power and ___________.
Move away quickly
200
What personal protective equipment is required before operating the scroll saw?
What is Safety glasses
200
Students should not rush laboratory work because it may lead to _________. (list 3 things)
Injury/accidents, damage to equipment and poor project quality
300
How must the saw blade be held after the cut is finished and before the blade stops rotating?
Hold it in the down position
300
To prevent the blade from binding in sharp curves, ______________ cuts should be made.
What is Relief
300
If you push too hard what will happen?
The blade will break
300
What personal protective equipment should be worn when operating a machine that is very loud like the planer?
Ear/hearing protection
400
True or False: You should leave the miter saw plugged in when it's time to clean up
False
400
The blade on a band saw is a ________________ steel band with alternating teeth.
What is Continuous
400
What should I do if the saw breaks?
Unplug the machine and notify the teacher immediately
400
At the end of class, the laboratory should be ___________.
Cleaned and tools are back to it's proper spot
500
What is the letter B pointing to?
Bevel Lock
500
Our machines are ______ inch band saws. The upper and lower wheels are that diameter.
What is 14 (fourteen)
500
What should I do when setting up the machine?
Make sure the machine is unplugged and it's on low speed and the light is off. Put the blade onto the machine and tighten the blade and clamp the blade clamp and flick the blade.
500
The Z-87.1 logo and manufacturing emblem on shop safety glasses tells the users that the glasses are?
The glasses are rated for our shop environment