General Shop Safety
Something you must obtain before operating any machine
What is a Student Tech Pass?
The name for the most common cut made with the Mitre saw
What is a Mitre Cut?
Something that should always be used on when working with small pieces
What is a push stick?
Something that screw divers, chisels or files should not be used as
What are pry bars?
Something about the disk that should be checked before using (always work on the downward/right side).
An acronym for what you must wear in the shop
What is PPE?
Any piece should be clamped down if it is shorter than this many inches
What is 6 inches?
The distance of how far one's hands should be from the blade.
What is 2 inches?
Something that should be done to each tool after use
What is cleaning?
These should be rolled up before using machinery
What are sleeves?
This should be watched for when cutting small pieces
The best type of blades used for cutting tight curves
What are narrow blades?
Something that every chisel, knife or blade you use should be
What is sharp?
Something the stock should be kept in to prevent burning due to friction
What is motion?
An essential shop item that should be used anytime there's an injury in the shop
Something the blade should fully attain before being lowered to the material
What is speed?
Something that you should seek when working with long pieces
What is assistance?
Something every chisel, knife or blade you use should not be
Something that will happen to the abrasive if you sand work that has glue or finish on the surface
What is ruin?
The colour of the emergency electrical power shut off signs
What is red and white?
The type of cut never to be made with a Mitre Saw
What is a rip cut?
The distance the upper blade guide should not exceed above your word piece
The direction you should strike a chisel from/to yourself
Something you should use the entirety of
What is the belt?