Definitions
Maintenance
Operation
Spiels
Skysleds
100

This is a required wind speed measuring device mounted no lower than 3/4 of the way up the flight or launch tower with a readout near the E-stop or workstand

Anemometer

100

The secondary clips are inspected 

Weekly

100

This is what the flight suit release rings connect.

Flight suits to the launch release system

100

This is what the flight suiter says to new flyers as soon as they greet them

Please step into the leg loops.

100

This is the amount of O rings on the skysleds that get connect onto the flight cable for each skysled.

4

200

Flashing light and horn that is activated when the winch is given an electrical command to winch down

Down Safety Alarm

200

The counterweight cable is inspected 

Monthly

200

Who says "The floor is going to fall away"

Assistant Controller

200

This is what is said as soon as the flight suiter confirms who the ripcord puller is going to be

This is your ripcord. When you reach the top of the launch tower, put your hand on the ripcord. When you hear 321 FLY just give it an easy pull and enjoy your flight.

200

This is the person that attaches the skysleds onto the flight cable.

Assistant Controller

300

Parachute industry style snaps used on the launch release system and all new flight suits to connect flyers together

B-12 Clips 

300

The Hydraulic Lift is inspected _ or _ for a seasonal park.

Semi-Annual

Annual

300

This is what happens when the Hydraulic Landing Unit is set to heavy

Flyers are at risk of a shoulder or arm injury

300

This is given when instructing flyers on how to slow down at the end of the flight

In order to slow you down after your flight all flyers must gran onto the loop with both hands and hold on tight until instructed to release the loop. There is going to be a pulling resistance similar to picking up a 50lb suitcase.

300

This is what the Assistant Controller instructs the flyers to do when they are placing them into the sitting position.

Fall back into your suit, keep your legs straight and do not bend your knees.

400

End of the winch drum shaft this mechanism prevents high-speed, uncontrolled lowering of the flyers in the event of a hydraulic failure of the winch 

Overspeed Clutch Assembly

400

The winch motor load adapter is inspected _ or _ for a seasonal park?

Semi-Annual

Annually

400

This would be the environmental restrictions for Skycoaster

Lightening within 5 miles

Wind above 30mph

Fog - loss of visibility of flyers or flight line 

400

This is said when Controller has the flyers step into their footbars

Drop the footbar and place your feet halfway on the bar.

400

In order to slow down double flyers at the end of the flight, all flyers should be instructed to grab the loop and hold on tight. Both flyers have to grab the loop.

Incorrect only one has to grab the loop and they should do so from the side.

500

2 individual electromagnetic switches located on the winch drum.  

Proximity Limit Switches

500

The Hyrdaforce Pressure Release Valve is tested

Monthly

500

This is the time limit the Controller has to set the proper setting on the Hydraulic Landing Unit

60 seconds

500

This is what is said by the Controller when they are attaching new flyers to the flight cable on the rolling boarding platform

Nothing the Controller does not attach the flyers

500

When flying a double flight on the skysleds, after you connect the side clips, and the bottom and top rings what is the next step that should be done

You have to attach the suits in all the Velcro areas which there is two on the bottom and two on the top.