SMAW basics
A heat setting is also referred to as this.
What is amperage.
In the designation E7018, the E stands for.
What is electrode.
The polarity we use most often for SMAW.
What is direct current electrode positive/DCEP or Reverse polarity
The type of clothing we are to wear when welding using the SMAW process.
What is dark colored, leather or cotton clothing.
The hand tool used to chip slag from the weld.
What is a chipping hammer.
The force that maintains the arc between the electrode and the workpiece.
What is voltage.
The way in which we determine the electrode size.
What is by the diameter of the metal core wire.
What we use to connect our work piece to the welding machine before welding.
What is the ground clamp.
We require these 2 things in a shop environment to protect our breathing air at all times.
What is adequate ventilation and a respirator.
This tool has a pre set 90 and 45 degree angle
What is a combination square or TRI-Square?
What is used to hold the welding electrode for SMAW.
What is the stinger.
The covering of a SMAW electrode.
What is the flux.
The final step in the safe shut down of a welding machine.
What is turning the power to the welding machine off.
A fillet weld should have equal what, unless specified?
What are equal legs.
A 3/32 electrode is also identified in mm, what is the size in mm?
What is 2.5 mm
The post weld clean up for SMAW welds.
What is slag removal.
What electrodes are not kept in the oven.
What are E6010.
What makes a welding machine portable.
What is an engine driven power source
Name three weld defects.
What is porosity, undercut, excessive spatter, cracks and overlapp.
What you use to cut 1/4" coupons.
What is the shear/iron worker/plasma
SMAW welding can be done in what position(s).
What is all positions.
The minimum as welded tensile strength of E6010
What is 60,000 Psi.
The terminal that the ground clamp is plugged into when welding with direct current electrode positive.
What is the negative terminal.
Why is it unacceptable to place 6010 rods in our oven
They are designed to have 3%-7% moisture levels
1/8 or 3/32, which electrode would produce the larger weld?
What is 1/8.