PPE
Warning Signs and Barriers
General Safety
Feeling Frisky
100

Hards hats should be replaced if they fail inspection or after...  

What is 5 Years of Use?

100

Smoking is only allowed in these areas.

 What is a Designated Smoking Area?

100

A required practice when climbing or descending stairs, ladders and platforms.

What is 3 Points of Contact?

100

Access is restricted unless escorted by an authorized card holder.

What are TWIC Restricted Areas?

200

When cutting and grinding or handling chemicals this secondary protection must be used.

What is a Face Sheild?

200

This is used when a warning barrier is needed but imminent danger does not exist.

What is Caution Tape?

200

 A large percentage of the work-related injuries across the nation are caused by wet surfaces, spills, or weather hazards.

What are Slips, Trips, and Falls?

200

To the Flagpole, To the Contractor Lot, To the Intake.

Where are the Muster Points?

300

 Unless necessary for unusual activities these are not required in the following areas: Control Room, Administration Building, Warehouse Office and Temporary Office Trailers.

What is PPE?

300

Waterproof and capable of withstanding 50lb. force the Date, Reason, and Person installing should all be included.

What is a Barrier Identification Tag?

300

Employes's shall maintain work area in a clean and orderly condition.

What is Housekeeping?

300

Can not be seen but heard at up to 1000°f.

What is Superheated Steam?

400

When working in or near high traffic areas this type of apparel may be required.

What is High Visibility Clothing?

400

Employees may not enter the area unless they are directly involved in correcting the hazard or have obtained permission from the person in charge.

What is Danger Tape?

400

Hard hat, Safety glasses, Work boots, and Hearing protection are required in industrial areas.

What are the Minimum PPE Requirements?

400

“That Is Correct!”

What is 3-Way Communication?

500

Loose sleeves, ties, cuffs, or other loose clothing should not be worn around...

What is Rotating Equipment?

500

“A gap or void 2 or more inches in its least dimension in a floor, roof or other walking/working surface” - OSHA

What is an Open Hole?

500

All employees who discover unsafe or hazardous conditions have the right and responsibility to use.

What is Stop Work Authority?

500

UN-1049

What is Hydrogen?