JHAs/PTPs
This is how often a JHA must be completed as a 30-day look ahead.
What is each month (every 30 days)?
Every effort should be made NOT to do this on the project site.
What is cutting material on the project site?
This hard hat type is required onsite.
What is a Type II hard hat?
Fall protection is required for any work over this height.
What is over 6 feet?
This rule keeps a worker from leaning too far, your belt buckle stays between the side rails.
What is the Belt Buckle Rule?
A detail-oriented document that discusses each individual task associated with an overall scope of work.
What is a Job Hazard Analysis (JHA)?
From the slideshow, these two tools mentioned are identified as “tools of last resort. (Think: cutting)
What are reciprocating saws and portable band saws?
These gloves are required at minimum.
What are gloves with minimum ANSI Cut Level 4?
This is mandatory in MEWPs.
What is mandatory tie-off (100% fall protection) in MEWPs?
On this project, ladders are chosen in this order: ________.
What is last?
A daily and more in-depth version of a JHA, completed prior to each shift or any time the task changes.
What is a Daily Pre-Task Plan (PTP)?
Onsite cutting using last-resort tools requires this plus prior approval by JE Dunn Safety.
What is a task-specific JHA?
This eye protection standard is required.
What are safety glasses meeting ANSI Z87.1?
These are NOT permitted on site; you must use an SRL instead.
What are bungee-style/shock-absorbing lanyards?
Only this ladder material is permitted onsite.
What are fiberglass ladders?
After lunch, this must happen to address changes in tasks, equipment, or conditions.
What is reviewing the PTPs with the entire crew and updating it if needed?
This is required when operating these last-resort cutting devices—no single-hand use is permitted.
What is using two hands to operate the device?
This clothing class is required on site.
What is Class 2 high-visibility clothing or a vest?
The first fall protection offense results in this.
What is a two-day suspension from the project site and mandatory re-orientation before returning?
This must be completed, documented, approved, and left in the work area before ladder use.
What is a ladder permit?