Cable loss
Cable Knowledge
CPE
Ingress
Installation
100
This is the term used for the loss of signal over cable
What is Attenuation
100

What is the purpose for using a grommet at the tap port?

What is Weatherproofing the drop fitting

100

This device is considered the demarcation point for Spectrum Phone

What is the eMTA (embedded multi media terminal adapter)

100
This test on your SLM will show ingress in the upstream spectrum
What is Ingress Scan
100

How should the drop cable's exposed wire braid appear after its been pro.perly prepared for a new connector

What is Evenly folded back

200

Very high frequencies will travel along the outer layer of the center conductor

What is Skin Effect

200

Why do we bond our cable system to a common ground at the electrical service entrance.

What is It protects people and equipment.

200

Which Statement about dual phone jack wall plates is True?

What is In some installation scenarios, you are required to bridge the upper and lower jacks.

200

Your OneCheck Ingress Scan will test your upstream carriers as well as this frequency band

What is the FM band 88-108 mHz

200

This type of connection is used to pass baseband audio and video signals. It does not support high-definition.

Audio will be in stereo (when available)

What is Composite Video (RCA)

300

An upstream level of 45.2 dBmV, after passing through a 2-way splitter, should read approximately

What is 48.7 dBmV

300

Which general statement about channel bonding is True?

A charter approved DOCSIC 3.0 or higher modem must be installed when channel bonding is required.

300

This device is a modem, router and eMTA

What is a gateway/AWG

300
The Ingress Scan is for troubleshooting cables within the _____________
What is the customer's premises
300

Grounding/Bonding is most preferred here

Power Company IBT

400

A customer's drop cable is disconnected from its tap port and connected to your test equipment instead. An Ingress spike is measured at a strength of -10.0dbmV.

Which statement best describes this measurement?

What is A serious issue exists within the drop system and must be corrected immediately

400

The operational data rate of 256 QAM

What is 38 Mbps

400

A resource you can use to identify frequency, receive levels and verify STB IP address

What is Box Diagnostics

400
Ingress is
What is Unwanted signals entering the cable plant
400

Which crucial step of a new install comes after all cable has been run and all CPE is activated?

What is customer education

500

Calculate what the channel 2 (54-60MHz) input level should be at the ground block when the tap output is 10dbmv on channel 2 with 150' of drop cable between the tap and ground block. (Drop Cable Manufacturer Loss Table States :1.60 db per 100' @ 55MHz)

What is 7.6 dbmv

500

A technician is using their SLM's ingress scanning function to check the shielding integrity of the drop system. They connect the SLM to the home's splitter at the port labeled In and with all of the outlets hooked up. If good, tight, system, what should they see on the meter?

What is Noise floor below -40 dbmv

500

A kind of device which is affiliated with a grandfathered account

What is Legacy

500

If testing for ingress on a splitter, you would connect your jumper from Port 2 on your meter to the ______ of the splitter

What is Input

500

What is the charter specification for modem receive levels?

What is Between -10 dbmV and 12 dbmv