Show:
The Channel Strip
The Master Section
Signal Flow
The Patchbay
Outboard Gear
100
By pressing this button, the input will switch between the preamp & the line input on each channel.
What is the FLIP button
100
This status assignment creates a "preferred tracking" scenario where the small fader is on the channel path & the large fader is on the monitor path
What is RECORD status
100
This is the signal flow step that comes directly after SOURCE
What is MIC or DI BOX
100
This output row is used to send signal to outboard dynamic gear
What is INSERT SEND
100
This digital device is a 2-track recorder & will be used to create final mixes in the SSL
What is the ALESIS MASTERLINK
200
This button bypasses the routing matrix & sends the output of the channel path DIRECTLY to the multitrack.
What is the FADER button
200
This monitor mode button must be activated in order to monitor through the Mackie (mini) speakers
What is the MINI A button
200
This step occurs directly before the Routing Matrix
What is SMALL FADER
200
This input row routes signal to the input of the monitor path
What is TAPE MONITOR INPUTS
200
This is the monophonic compressor made by UREI
What is the 1176.
300
This button, located in the INSERT SECTION, assigns the Insert Return patch point to act as a side chain input for the dynamics section
What is the KEY button
300
This communication button sends the talkback mic feed to the headphones, thusly becoming the "talkback button"
What is the F/B A button
300
This step directly follows the Tape Monitor Inputs
What is the SMALL FADER
300
This output row is fed from the wallbox
What are MIC LINES
300
These are the parallel effect units available in the SSL
What is the TC M2000, & TC D2
400
This button assigns the GROUP OUTPUT to feed the input of the monitor path, as opposed to the multitrack return.
What is the GROUP button
400
These are the three ratios available on the stereo mix bus compressor
What is 2:1, 4:1, and 20:1
400
This is the last step of the SSL signal flow
What is the SPEAKERS
400
The Aux sends are labelled as this on the patchbay
What are FX
400
This stereo compressor can be linked or act as two independent mono compressors
What is Focusrite RED 3
500
The expander is activated by pulling on this pot of the gate
What is the HOLD pot
500
This solo mode only allows for one channel to be solo'd at a time
What is ALT
500
This step occurs directly after the Routing Matrix
What is GROUP OUTPUT
500
This output row is the output of the routing matrix
What are GROUP OUTPUTS
500
This piece of Outboard gear is used to "shape" the transient of a sound, namely kick drums
What is the Transient Designer