Safety
Safety II
Safety III
Safety IV
Safety V
100

A Hang-fire is:

is a delay in Functioning  of  either  Electronics or  Explosive  Components  Caused  by:

•Loose Electrical Connections

•Damaged  Propellant

•Misalignment of Components

100

The ten-minute wait is a safety window for? 

The missile battery to completely drain.

100

•The missile must not be approached for ____ minutes and must not be handled for ____ minutes during a misfire, or dud conditions

30 minutes, not handled for 60 minutes.

100

What are the Minimum  and Maximum Firing Angles

10 Degree Min. Elevation-- 65 Degree Max.Elevation

100

least-preferred method to destroy the Stinger Weapon System

 Burning

200

During a Hang Fire  what Actions do you take?

1. Continue Tracking 3  to  5  Seconds  keeping

      the Uncage Switch and Trigger  Squeezed.

  2. If  Missile has not Ejected  after  5  Seconds,

      treat as misfire.

200

After 30  Minutes, Weapon  Round  may  be  moved  for  Disposal  by ___  .   You Keep  Weapon Round  under  Surveillance  until  Destroyed since  it  is____

EOD, Classified

200

BCU  temperature  can rise up  to  +400°F or more  within _____minutes.

  10 minutes.

200

What is the Launch Tube Aft End Ground Clearance

30 inches

200

Why should you destroy the missile in the enemy’s direction?

To prevent, deter, and disrupt enemy movement.

300

A Misfire is what?

a complete failure to fire because of faulty electronics or components. If the Missile fails to fire, always assume it is a Hangfire first

300

What is A Dud?  

when  the Missile  Flight  Motor  does  not  Fire  after  the Missile  has  ejected from  the Launch Tube. The launch motor will coast the missile for about 28 feet (8.5 meters)

300

The BCU should be removed after ___ seconds but must be removed within ___ minutes after activation to prevent damage to the grip stock.

45 seconds, 3 minutes

300

Best Way to destroy the Stinger Weapon System?

Firing- The most preferred method is to fire the weapon system.

300

Destruction by demolition requires how much TNT/C4

3.5 lbs of TNT

400

What are your Misfire Procedures?

1. Continue  Tracking  3  to  5  Seconds,  keeping  the  Uncage  Switch  and  Trigger Squeezed.

2. If  Missile  has  not  Ejected  after  5  Seconds, Release  Firing  Trigger  and  Uncage  Switch; then  Immediately  Remove  the  BCU  and  IFF  Cable.

3. Place  Weapon  in  a  Dud  Pit  or  on  the  Ground, 164  Feet  (50 Meters) from  the  Firing  Position pointed  Down  Range and elevate missile no more than 20 degrees.

400

What are your DUD Procedures?

1.  Mark the location of the Dud and immediately notify EOD.

2.  Missile should not be moved for 60 minutes. Other Missiles may be fired during this hold period.

3.  Since the Missile is Classified, it must be under surveillance until moved or destroyed.

400

Do  not  handle  BCU  for ____ minutes  after  removal.

30  minutes

400

When Destroy the Stinger weapon by using demolition, If using nonelectric caps they must be crimped to at least with ____feet of safety fuze.

5 feet

400

When using gun fire as a method of destruction all personnel must be ______ Meters from the missile?

457 Meters

500

All support personnel within ___ meters (___ yards) must remain under cover for ___ minutes. 

125 meters (137 yards)

 ten minutes

500

•Hang fire, misfire, or dud missile conditions are hazardous. For the first ______ minutes?

10 minutes

500

Is it safe to point the BCU directly at the skin after removing it from the grip stock?

No, do not point  toward skin because high pressure gas may still be escaping

500

Once you have engaged the target, you must ensure you destroy the _______, to include the ______, to prevent the enemy from using it to their advantage.

empty launch tube, to include the sight assembly

500

In the event of being over ran, you must destroy the gripstock. What is the most expedient way to do this after the missile is fired?

leave the BCU inside of the gripstock more than three minuets to allow for melting. Ensure the RMP module is completely destroyed.

600

During a hang-fire, misfire or dud personnel must remain under-cover for how long?

10 min.

600

The SKL does not need to be destroyed, however you must _____ and remove the ___,____,___ (CIK).

zeroize, crypto ignition key

600

To destroy the BCU in an expedient way,What is the best way?

Place the BCU inside of the BCU receptacle and press the safety and actuator device

600

The IFF MUST be taken with you in the event you have to escape and evade! If you cannot carry with you, then destroy by:

Cutting: Ensure ALL cables are cut.

Mutilate: Bend all pins/ports beyond repair.

Smash: Smash the IFF beyond repair.

600

True or False: All Overlays containing movement information, team positions, higher echelon locations, and friendly asset location should be destroy

True

700

Prior to receiving and unpacking the Stinger weapon round, what procedures must be performed before firing.

Perform the 13 critical checks

700

What holds the blow-out disk in place on the missile

Protective shock ring

700

WHAT COLOR IS THE PAINT ON THE SCEWS ON THE RANGE RING AND REAR SIGHT

BLUE

700

What is the Stinger operators' Manual TM #?

 TM 9-1425-429-12

700

What does RISTA stand for?

Reconnaissance, Intelligence, Surveillance, and Target Acquisition