for the fruity trades
you are never supposed to use these when plugging in the sump pump
extention cord
motor sizes for a sump pump
1/4hp, 1/3hp, 1/2hp, and 3/4hp
this pump shreds all solids to a fine slurry
grinder pump
how far should a sump pump travel away from a home
10-20 feet
check valve
this is installed to protect you from malfunctions
pump alarm
motors used for sewage ejector pumps
1/2hp, 3/4hp, or 2+hp
the reasoning for a sump pump
to push ground water away from the foundation of the home
friction and how far it runs
the weep hole(vent hole) should be where on a sewage ejector pump and sump pump
just above the check valve(sump pump) and just above the ejector pump
dedicated 120 volt circuit
the discharge pipe size for 1/3hp, 1/2hp, 3/4hp and 1hp
1 1/2in for 1/3hp and 1/2hp. 2in for 3/4hp and 1hp.
this pump uses a scissor like blade that breaks down solids
cutter pump
the pump hp required for a vertical lift of 10-15 feet(sump pump)
1/3hp or 1/2hp
when installing a basin, you need to dig this far down
30 inches down
if motors are drawing more than 7 amps they require what
a 20 amp breaker
standard sizing for discharged piping for residential and commercial(sewage ejector pump)
2in and 3+in
the purpose of the sewage ejector pump
to pump raw sewage from below grade fixtures upward to the sewer main.
the horizontal run and vertical run significantly reduces the pumps ____ output
gpm(gallon per minute)
how are both pumps vented
sewage ejector pump vents through the roof while the sump pump vents through holes on the lid of the basin
the standard volts a sewage ejector pump requires
115v or 230v
for a entire basement with multiple fixtures this would require what size of pipe and hp(sewage ejector pump)
3+in and 1+HP
this pump moves larger volumes of waste.
non clog pumps
a basement only has one bathroom and a laundry room. this hp and discharge pipe size would be sufficient.
this is required to install on the ejector pump but not on the sump pump
ball valve