Safety
Do this with ties, coats, long sleeves, etc. when using the table saw.
What is remove or fasten them out of the way?
When setting up the table saw, the saw blade should be checked for these.
What are cracks and missing teeth?
What would happen if we did not utilize a riving knife/splitter?
What is kickback?
This type of stock should never be ripped on the saw.
What is round stock?
True or false: you will utilize the push stick to make a Dado cut.
What is false.
List 3 items that should not be worn when operating the table saw.
What are rings, gloves, bracelets, etc?
After a cut has been completed, you should do this before leaving the table saw.
What is lock up the saw?
True or false: You should use both the miter head and fence together for extra safety.
What is false.
A push stick must be used when a material is less than this.
What is 6 inches?
Name 3 Parts of the table saw.
What are......
List the 2 types of protective equipment that should be worn when operating the table saw.
What are safety glasses and ear protection?
Before locking the table saw, grabbing materials, rolling up shop doors, etc., always do this.
The saw blade should extend this far above the stock being cut.
What is 1/4 inch?
What do we use when making cross cuts or miter cuts?
What is the miter head?
When ripping warped lumber, how should it be placed on the table?
What is bow side up?
What is over-reach when feeding material through the saw?
List the steps of locking up and putting away the table saw.
What is: Roll up power cord, put away miter head, roll down blade, make sure fence is put back, lock legs, roll back into shop.
When long materials are crosscut on the table saw the operator needs this.
What is auxiliary support.
When making bevel cuts, the hands of the operator should be placed where?
What is the opposite side from which the blade is tilted?
Which operation requires the use of the push stick?
What is a rip cut with less than 6 inches of width?
List 5 unsafe practices when using the table saw.
What are standing in line of the blade, not wearing safety glasses, not rolling up long sleeves, wearing rings, not tying up hair, etc?
Name 5 Parts of the table saw.
What are........
Name 3 cuts we can make with a table saw, but not a miter saw.
What are Dado, Rabbet, and Rip cuts?
Loosely holding the material against the miter head may result in this.
What are poor cuts, binding of the blade, material vibration, etc.?
The miter head is calibrated in these.
What are degrees?