General Safety
All students should ask for __________ before operating the table saw for the first time.
Permission
Daily Double!!
The SawStop system only activates once _______ is detected and should be used as the _______ measure to minimize injury.
Contact, Last
Use a push stick when ripping pieces smaller than _____ inches or whenever necessary.
Six
While operating the table saw, it is never a safe practice to _______ your workpiece through the saw. You are just inviting Kickback!
Force
Which item listed below is ok to wear while working in the lab?
Loose Clothing, Gloves, Closed Toed Shoes, Jewelry
Closed Toed Shoes
During standard ripping and crosscutting operations the blade should extend above the material by __________ of an inch
⅛ or about one tooth
When ripping you should use the _______, and when crosscutting you should use the ____ ____.
Fence, Miter Gauge
When the distance between the fence and the blade guard is too tight a ________ must be installed instead of the blade guard assembly.
Splitter/Riving Knife
Always wear proper ___________ protection, even if you already wear eyeglasses.
Eye (Safety Glasses)
Only cut material that has a _______ edge.
Straight
Wait until the blade has completely ________ before walking away or removing small pieces from the guard.
Stopped Moving
The saw should reach _______ operating speed before making a cut.
Full
While operating the saw you should talk to ______, the only exception being your instructor or the person catching the board for you.
No One
Before any cutting operation be sure the _________ _________ and _________ are in place.
Blade Guard and Splitter
The saw operator should stand to the __________ of the blade during cutting operations.
Left
The safe operating position for your hands is to hold the board tight to the fence with you left hand and push the board through the saw using a ______ ______ with your right hand.
Push Stick
To prevent making contact or getting tangled in the blade or moving parts, _____________ should be put up or tied back?
Hair
No adjustment should be made to a machine unless the ________ is off.
Power
When ripping a long board a ________ or a
_____ _____ can be used to support long material.
Partner, Outfeed Table
When ripping, place your workpiece with the straight edge tight against the _________ and flat on the __________.
Fence and Table