General knowledge
This component is located directly in front of the pressure switch in the plenum box.
What is the vacuum switch?
These Components make up what? The Battery control unit, the shunt sensors, GCU, generator, EHPDU and the APU.
What is the BMMS?
This will start automatically when the start-up is complete if volts are less than 23v.
What is Tac Idel?
This light will illuminate approximately 3-4 seconds during CDU power up.
What is the FTL indicator?
This LRU process the solution for the fire control system.
What is the MCU?
This component has to be pressurized to 200psi
What is an accumulator?
This component will start automatically to cool down hydraulic fluid.
What is the Thermal Management System?
This Fault is displayed first if you have more than one at a time.
What is the most critical fault?
This LRU process the operator processes inputs, controls the weapon station accordingly and feeds live video to the CDU.
What is the MPU?
What must a crew member do to apply range to a ballistic solution.
What is grab the power control handles?
The Gun and GPS follows the CITV in this mode.
What is CITV Gun LOS?
This happens while the vehicle master power is off and the batteries are idle, the assembly operates in low power configuration where monitoring rates are reduced and Controlled Area Network (CAN) bus communication is halted.
What is Standby mode?
When this happens, the screen will go 50% brightness if it is below 50%. If the screen is 50% it will turn to 100%. Give 2 examples!!
What is NBC Main Disable, NBC chemicals, NBC nuclear radiation, Main Engine fire, Overheat Sponson in and overheat sponson out.
This provides 24volts of direct current to the CITV SEU.
What is CRSM 5 device?
These components measure pitch, roll and yaw.
What are dual access gyros?
The Forward Module, Rear Module, Accessory Gear box and the Reduction gear box make up what?
What is the AGT 1500 four modules?
This happens whenever a high demand for hydraulic power occurs, power to the VCSU refrigeration loop is cut off and the TMS operates the PGW loop only with the AHU fan set to low.
What is Automatic hydraulic power prioritization?
The Tank engine speed will automatically go to tactical Idle when performing this function.
What is PVT?
Note wp 0081
Engine speed will automatically go to tac idle (about 1200 rpm to 1400 rpm) when shift control is set to PVT
If an out-of-range value has been entered this will happen.
What are question marks?
????
This is the rotational movement around an axis.
What is yaw?
Hydrogen and helium are operating gases in these sensors.
What is the Apu Fire Sensors?
What is the time needed that the TMS has to run in order to cool the Hydraulic fluid temp high fault.
What is 15 mins?
Corrective action 1. Start engine volume 1 wp 0066
This LRU has to be turned off before powering up any station.
What is the Dome Light?
This component houses the Azimuth stow and AZ release Assembly.
What is the Main Frame Assembly?
This device senses and reports the main gun position.
What is gun trunnion resolve?