Distilling
Separates the hydrocarbon liquids for upstream processes into Naphtha, Diesel, Jet Blend Streams and recycles UCO.
Name and Unit#.
What is the Distillation Process? 520.
Removes Contaminants (solids and water) and converts the liquid hydrocarbon streams into a liquid blend of the final product constituents which are later separated in a downstream process.
Name and Unit #
What is Product Upgrading? 510
Increases the hydrogen and recycle gas pressure to the conditions needed for product upgrading.
Name and Unit #.
What is the Make-Up Gas Compressing Process? 510.
The kind of reaction that takes place in FT 1&2.
What is an Exothermic reaction?
The difference between the reactors in FT 1&2 and FT 3.
The EFT reactors in FT 3 are Vertical.
List the final constituents in order from lowest to highest boiling point.
Naphtha
Jet(kerosene)
Diesel
UCO
The piece of equipment where catalyst facilitates the specific reaction required to remove contaminates such as nitrogen, sulfur, oxygen and metals.
What is the Hydrotreating Reactor?
DOUBLE POINTS!
Walk through the Recycle Gas Compressing sub process.
Open Ended.
This process happens every three or four months to clean the catalyst.
What is FT Regeneration?
The Percentage of water produced in the reactors in FT 3.
28.6%
Tray Number where Jet Blend is taken from the Fractionation Column.
Tray #10
The piece of equipment where catalyst facilitates the specific reaction required to convert heavy oil fractions into a lower molecular weight mainly saturated hydrocarbons.
What is the Hydrocracking Reactor?
DOUBLE POINTS!
Walk through the Make-Up gas compressing Stage 1 and 2.
Open Ended.
The total number of reactors in FT trains 1&2.
Four Reactors.
The Quench overhead temperature.
400of
Tray number where diesel is taken from the fractionation column.
Tray # 22
Two additives used in the product upgrading process.
What are DMDS and Ammonia?
Users of the Recycle Gas.
Hydrocracking Reactor, Hydrotreating Reactor, Reactor feed/ Effluent Exchanger, and the Fuel Header
The amount of sulfur allowed into the FT train 1&2 process.
<10ppbv
The three steps of FT Regeneration in order.
Wax Removal
Oxidation
Reduction
DOUBLE POINTS!
Walk through the feed heating and fractionating sub processes.
Open ended.
Pieces of equipment where water is removed from the Wax and Condensate streams by gravity.
What are the Wax and Condensate feed surge drums?
1074 psi
The purpose of the Steam Drums in FT 1&2.
The Steam drums supply BFW to the FT Reactor jackets to remove heat and produce medium pressure steam.
This Process is bypassed during the wax removal and oxidation sub processes.
What is the Hydrogen Drying sub process.