Screwdrivers
Pliers
Torque
General Tool
Pressure
100

This type of philips screwdriver seems to be the most common in small engine repair. 

#2

100

This is often used to cut wire. 

Diagonal Cutters
100

These types of torque wrench that is typically used for rolling torque. 

Dial Torque Wrench

100

What type of tool can read in Celsius?

Temperature reading tool, Temp gun

100

Air leaking out of an carburetor during a leak-down test would indicate what problem?

Bad intake valve

200

This is often used to adjust mixture screws on small gas engines. 

Small standard screwdriver

200

This tool is used to grasp and lock onto something without having to keep a hand on pliers. 

Vice-grip, Locking Pliers

200

This must be applied to a fastener before it is torqued, if not it may bind and give you a false torque on fastener. 

Oil, Lubrication, Loctite

200

This tool is used to expand parts so they can be removed or installed. 

Propane Torch

200
Where does the engine need to be to perform a leak-down test?

Top Dead Center on Compression Stroke

300

This is a good rule of thumb when working with screwdrivers. 

Get away from your work. 

300

This is Noonans favorite pliers

Mid-length 45degreee offset needle nose pliers

300

This uses a ball and detent to indicate when you have reached the proper torque. 

Click Type

300

What tools is used so you do not break the piston rings.

Piston Ring Expander and Piston Ring Compressor

300

If you ran a compression test on a small engine. What would the outcome be?

Low compression, 

400

This type of screwdriver is common when dealing with plastic body components on powersports equipment. 

#3 philips

400

What is one thing you should not do with pliers. 

Tighten or loosen bolts/nuts

400

This is the metric measurement used on fasteners. 

Newton Meters

400

Where are the fuel hose clamps located if you needed one?

Shop Tool Box 1

400

If you had and engine that when you poured oil down the cylinder and the leak-down test showed improvement. What is the possible cause of the initial low reading?

Bad Piston Rings

500

What part of the screwdriver is under warranty?

Shank

500

What type of wrench is used when turning the pto side of a crankshaft on a small gas engine?

Adjustable Wrench

500

These are the American units of measurement for torque.

Inch Pounds/Foot Pounds

500

What uses the collapsing circuit in an engine system to create an observable reading? 

Engine Tachometer, TA-100

500

If an engine had 100% leak-down. What would the next step be?

Re-test