landing gear
what are the three indications for the landing gear.
up
barber pole
tires
How many ignition Exciters are on each motor?
2
01-75pac-2-13-1-2
how often do i have to do a fresh water rinse?
every 14 days or see visible salt
wat is when discovered R used for
This code is used when a need for maintenance is discovered during any receiving, screening, in-process or final QA inspection (scheduled or unscheduled) conducted by personnel acting in the capacity of QAR, CDQAR, or CDI.
where are the airspeed switches? what do they trigger?
01-75pac-2-13-1-1
rack c1
warning horn and landing gear handle lights
what are the inflight limits for prop de-ice cuffs and islands.
01-75pac-2-13-1-2
cuffs(51-72)
islands(63-82)
what does mesm stand for
Mission-Essential Subsystem Matrix
What are the reasons that would cause the need for a prop balance?
12 reasons
R/R of:
Prop, Eng, Spinner, RGB/mount/strut, frone/rear cone seat, heater, electrical contact rings
OR
Certain blend limits, cuff repair, erosion tape-> sealant on heater leading edge, excessive vibes, asym tip paint
03-20VAM-1 wp005-00 pg2
what is the part number for the number 2 probe in tank 5
01-75EPS-2-9-1
#99 20209-0101
what steps are required to be in an inpro.
any qa or cdi steps
what afc incorporates the landing gear warning horn
afc 460
01-75pac-2-13-1-1
During engine startup fuel begins flowing out the low point drain and engine does not light off.
Give the three components that could cause this gripe.
Ignition Relay, Geneva Lock, Speed Sense Control
01-75PAC-2-13-1-2
where is the quick disconnect cannon plug for tank 5?
hsc behind boost package
01-75pac-13-1-2
as per your cdi designation what factors will you not allow to affect your judgment.
1. operational desires
2. maintenance consideration
3. personal relations
4. or the approach of liberty
asm
how do the scissor switches affect fuel quantity
provides flight information to adjust attitude orders
what constitues a flight
namp, Appedix A-32
FLIGHT – A flight begins when the aircraft first moves forward on its takeoff run or takes off vertically from rest at any point of support and ends after airborne flight when the aircraft is on the
surface and either; (a) the engines are stopped, (b) the aircraft has been on the surface for 5 minutes, or (c) a change is made in the pilot in command. A series of landings is considered part of one flight and the provisions of (b) above do not apply. CNAF M-3710.7 contains a more precise definition