OSHA Focus 4
While taking down an existing wall a worker accidentally cuts a live wire
Electrocution
The spot where a worker ties off
Anchor
When lumber bends or twist away from a flat plane
Warping
What is the square footage of a room that measures 11' X 19 "
209 SQFT
Exactly vertical
Plumb
A worker is working on the first floor, and a tape measure is dropped from a 3rd story window. Hitting him in the head.
Struct by
Starting at what height does OSHA mandate you must use fall protection?
Six feet
Dimensional lumber
Wood prepared for use in a building, which is two inches to less than five inches thick, and greater than two inches wide
A carpenter needs two pieces of blocking. The first is 7 1/2" long and the second is 5 7/16". What is the total combine length?
12 15/16"
Weight to be supported
Load
While walking backwards carrying material a worker steps in a hole causing a broken ankle.
Falls
The piece of equipment that the worker wears in a fall restraint or fall arrest system
Full body harness
Timbers often scrap, used beneath or between layers of stacked material?
Dunnage
A worker measures a wall opening as 12 3/16". He needs to leave a1/8" clearance on each side. What length should the finished piece be?
11 15/16"
A condition in which two intersecting objects form a 90-degree angle?
Square
Attempting to walk around an excavator, a worker gets crushes by the counter weight and pushed against a dump truck
Caught Between
In the hierarchy of controls what is the safest form of fall protection ?
Eliminate the hazard
A hard and dense defect caused by an embedded branch of limb in a tree
Knot
A piece of lumber is 15 1/2" long. A 6 3/4" section is cut away. How much lumber remains
8 3/4"
The act of building something?
Construction
While working in an unprotected trench a worker is engulfed by soil that collapses
Caught in
What is the difference between fall restraint and fall arrest>
Fall restraint the worker cannot reach the edge or the hazard (like a dog leash)
The width of material removed during a cut
Kerf width
A carpenter needs 16 1/2" of trim. He already has a piece measuring 9 3/4". How many more inches of trim are needed?
6 3/4"
What can happen if a support column is not properly plumbed
Collaspe