Show:
ALARMS
TAK 55 UV System
Controls
Types of UV Systems
Measuring and Monitoring
100
The screen that is opened when the Alarm button on the Main screen is pushed
What is the Active Alarm Page?
100
Immersed lamp waste water channel
What is a TAK?
100
Located on the front of the cabinet, it is used to shut off all power to the components inside.
What is the Main Disconnect Switch?
100
Staggered lamp arrangement, no chance to miss concept OptiDose sensor-based control philosophy Validated according to US EPA UVDGM 2006
What is a K143 Reactor?
100
UV Intensity, UV Transmittance, Flow Rate, Outlet Gate Position
What are Analog Signals?
200
It turns red if there is a critical alarm
What is the High Priority Lamp?
200
Turbo Digital Smart
What is a TDS system?
200
it has a virtual keyboard and various screens that can be manipulated by touch
What is a HMI?
200
This type of UV system has modules that are lifted out of the channel by an electric motor
What is a Duron UV system?
200
This device is used to measure the depth of the water in a UV Channel
What is an Ultrasonic Level Probe?
300
This type of alarm warns the operator that there is a malfunction that will not necessarily affect disinfection
What is a Low Priority Alarm?
300
It can be fixed or modulating
What is an Outlet Weir?
300
A logic controller that is programmed to control a UV system.
What is a PLC?
300
Open Channel or Enclosed Vessel
What are two types of UV systems?
300
Located in a rack, this device provides an input to the PLC
What is an IO card?
400
This is used to clear an Active Alarm
What is the RESET button?
400
It's the measurement of the quality of the water that is being treated
What is UVT?
400
4488, 1024, 2048
What are UV System Passwords?
400
This type of UV system is enclosed and requires draining to perform maintenance
What is a UV Vessel?
400
SO13599 and SO13799
What are UV Sensors?
500
Cabinet Temperature High, Module Lifted/Disconnected, Water Level Low,
What are alarm conditions that turn OFF the UV system
500
PLC, Ballast Racks, UV Sensor Boards, sensor board SEC_KOME
What are components in the electrical cabinet?
500
Usually a signal generated from SCADA that is used to start the UV system
What is a Remote Start signal?
500
It is dedicated for process or product water in the food and beverage industry, the pharmaceutical industry or for processes in microelectronics and any other industry with higher demands on water quality.
What is Spektron i series
500
Usually not provided by Wedeco, this signal is used in the Dose Calculation
What is a Flow Signal?