More Surgical Hand Antisepsis & Scrub Attire
Sutures
Wound Closure & Healing
Draping
Surgical Staplers
100

True or False: The purpose of the surgical hand scrub is to sterilize the skin

False—skin cannot be sterilized; the purpose is to (1) remove debris and transient organisms, (2) reduce resident microbes to minimum, (3) inhibit rapid regrowth of organisms

100

These are two characteristics of polypropylene sutures

Non-absorbable

Monofilament

100

Does the insertion of a drain impact wound classification? 

The insertion of an open drain (i.e., Penrose) changes a Class I (clean) procedure to Class II (clean-contaminated)

100

The scrubbed person must ensure that his/her hands are this when placing drapes in order to avoid contamination

Cuffed

100

This technique is used to separate instruments that have come into contact with dirty or contaminated areas.

Bowel/isolation technique

200

This is how long the surgical scrub should take (by either method)

4-6 minutes (not including pre-wash of 1 minute)

200

These are the two suture materials that can be characterized as natural and non-absorbable

Silk

Stainless steel 


200

List 5 patient factors that influence wound healing

Respiratory and circulatory status 

Age

Pre-existing conditions (diabetes, renal failure, alcoholism, immunocompromising conditions)

Immune system response 

Nutritional status 

200

In order to prevent contamination, it is recommended that these drapes be placed first when draping for lithotomy

Leggings

200

True or False: All staplers stocked at VCH have a maximum firing of 8 times

False 

TLC = 8

TX = 8

Echelon = 12

CDH/EEA = 1

Contour = 6

300

Your first pair of gloves should be put on using this technique

Closed gloving 

300

Name at least two absorbable sutures

Vicryl 

PDS

Gut

Monocryl

300

What is a stitch that is separate and tied independently of other sutures called?

Interrupted

300

Identify at least 4 different types of drapes

Sterile towels 

Incise drapes 

Laparotomy drapes 

Upper/lower extremity drapes 

Lithotomy drapes 

Split sheets 

300

This is the correct way to unload and clean a used stapler

Carefully remove the cartridge using a sponge to avoid contaminating your glove 

Place the used cartridge in a separate area of the back table 

Rinse/swish the stapler in a jug of sterile water 

Wipe the anvil with a sponge to remove any excess staples/water/tissue 

400

Double gloving reduces the risk of injury/exposure; wearing two different colours of glove assists with this

Recognizing perforations in the outer glove

400

Arrange these sutures from smallest to largest: 8-0, 0, 3-0, 5-0, 2

8-0

5-0

3-0

0

2

400

Why is negative pressure wound therapy used? 

Decrease the edema and bacterial load 

Promote wound contracture and healing

400

Surgical drapes should be placed according to these principles

Drape from the incision site to the periphery (Exception: placing an approach sheet to allow better access) 

Drapes are handled as little as possible 

Cuff hands to avoid contamination 

The top surface of the drape is considered sterile 

Once placed, the drape is not moved

400

The surgeon asks for a TLC stapler, what information should you ask before going into sterile core?

Size (TLC55, TLC75, TLC100)

Colour/tissue type (vascular = white, regular = blue, thick = green)

Number of cartridge reloads 

500

When removing your sterile gown and gloves, this is the order they should be removed

Gown, then gloves; your top layer glove may be removed prior to the gown

500

This is the most appropriate needle point for performing vascular anastomosis

Taper

500

In this type of wound healing, closure is delayed due to gross infection or considerable tissue loss; the wound is cleaned, debrided, and packed

Delayed primary closure (tertiary intention) 

500

If a surgical drape is placed in an incorrect position, this is the best course of action

Discard and replace the drape

500

These are the two types of staplers you will require for a sigmoid colon resection with end-to-end anastamosis

GIA/TLC x2 firings

EEA/CDH x1 firing