RANDOM
Where is the wing inspection light located?
On the lower left side of the fuselage aft of the passenger door
Limitations of the NAI system while on the ground
The OAT less than 10c with presence visible moisture in the air
What type of tubes are arranged for hot bleed air to be discharged?
Piccolo tubes
How many seconds does the inflation cycle for?
6 seconds
ICE Mode 2
What is the WAI has failed?
Minimum and maximum holding speeds are?
60 seconds
Which mode can you not operate the NAI?
QPM
WAI System only activates during this time?
How many seconds for the deflation cycle?
54 seconds
Ice mode 1 is set every time icing conditions are encountered, the ICE signal is active, and is latched only for icing encounters that are more than how many seconds?
70 seconds
Maximum flap extension in icing conditions?
15 degrees of flaps
Control and monitoring of the NAI is performed by which system?
Utility Management System (UMS)
The system is inhibited when the TAT is higher than?
15C
When can the HSDI system operate?
It is permitted both on the ground and in flight
ICE Mode overrides
ICE mode 2 to 1 and 1 to zero
How many seconds does the WS EMER PWR provide heat the windshield for?
100 seconds
When does the amber CAS message "IPS ON-TAT Limit" triggered?
When the TAT is more than +10C and the NAI system should be switched off, unless there is an icing environment in which case, continue to use NAI.
Why is the WAI system inhibited on the ground?
To prevent overheating of the wing leading edge when there is no airflow over it.
When does the amber CAS message "IPS ON-TAT Limit" triggered?
When the HSDI is operating with a TAT below -40C.
What changes when either ice modes are detected?
The stall warning and stick pusher system is signaled to operate based on an adjusted datum shifting the stall warning and pusher activation threshold.