Tools
This is the tool we use to cut a board down to size.
What is a hand saw?
This is the name for the hammer we commonly use in the shop.
What is a claw hammer?
This is a tool used to measure the length or width of a board.
What is a tape measure?
These are something that you must always wear when working in the wood shop.
What are safety glasses?
This is a cylindrical metal piece with a sharp point, used to hold two pieces of wood together. You pound this item in with a hammer.
What is a nail?
This is used to hold pieces of wood together so you can drill or drive in a screw. Another option would be to hold the items in the vise.
What is a clamp?
This hammer is used to shape metal.
What is a ball peen hammer?
There are two of these in an inch.
What is a half inch?
This is what you should do if you injure yourself in the shop.
What is notify the instructor immediately?
We use these tools to remove pencil marks and smooth wood before we apply paint or finish.
This is a tool used to clean out a drain or remove a clog from a toilet.
What is an auger or drain snake?
This tool can be various sizes and can be used in demolition to break down walls.
What is a sledge hammer?
There are four of these in an inch.
What is 1/4 of an inch?
This is something you should never do in the shop, as someone could get hurt.
What is use the tools in an inappropriate manner?
This is used to make an indentation that will allow for the head of a screw to sit flush with or just below the surface of the wood.
What is a countersink bit?
This is a tool used to find a 2x4 in the wall in order to hang a heavy item on the wall.
What is a stud finder?
This tool is used when you don't want to damage the item you are hitting such as putting pegs in a hat rack.
What is a rubber mallet?
There are 16 of these in an inch.
What is 1/16th of an inch?
This is something that you should not wear when working in the wood shop.
What is loose clothing and jewelry?
This screw has a star shaped head.
What is a torx screw?
This is a tool that when hit a couple times with a hammer makes a spot for you to start your hole when you are using a drill.
What is an awl?
The end of this hammer is used to chip off pieces of stone or cut bricks.
What is a bricklayers hammer?
This tool is used to mark a straight line when you are going to saw a piece of wood.
What is a carpenter's square?
When using the drill you should make sure that this is always tied back.
What is long hair?
This is a tool used to determine if something is straight. It can be used when hanging a picture or putting a shelf on the wall.
What is a level?