Table Saw
The area should be
What is clean and free of clutter?
You should use _____ push pads.
What is two?
The cutting blades are located ________ the table and very dangerous.
What is above the wood surface?
Be sure that your stocks 90 degree edge is _____ against the fence.
What is squarely or flush?
A dado cut does not cut all the way __________ your stock/project piece.
What is through?
Before turning the saw on be sure a ........ is handy.
What is a push stick?
The greatest danger, beside the cutting head with blades, is ...... from the infeed table.
What is kickback?
The table surface is adjusted by
What is turning the wheel on the right side of the machine?
Be sure that your hand that is holding your stock is safely .... inches away from blade position.
What is 6" ?
Be sure that the dado stack or router bit you have chosen is set to the correct _____.
What is the Width, or Depth or Height?
Place your board against the blade to determine the .... for the desired rip cut.
What is the height of the blade?
Be sure to push your wood stock ......
What is all the way past the red safety cover?
You should accurately measure the _______ of your stock carefully with a tri-square.
What is the thickness?
Before pulling the saw handle out into position to descend and cut your stock, let the motor ....
What is reach full RPMs with a 5 count?
Accurately mark your stock and adjust the _______ of the dado stack appropriately. Be sure the guide fence is positioned correctly too.
What is the height?
The blade height should be........above the board.
What is about 1/4" or slightly less?
You should only do ______ surface and _____ edge on the jointer.
What is one surface and one edge?
Set the height of the table accurately to match the _______ of your stock.
What is the thickness?
Be sure to ________ the blade all the way down and ________ it all the way forward slowly.
What is lower and push?
If you are using a router to cut your dado be sure to use a ___________ to stay accurate and straight.
What is a straight guide? Be sure the metal guide is is accurately clamped!
If the fence is not locked in place there is great danger of .......
What is kickback?
Please do not change the ________ or guide angle of the jointer without Mr. Pulver's permission.
What is the depth or amount of wood removed?
Never turn the adjustment wheel raising the table more than ______ turn.
What is 1/2 ?
Be sure that the miter adjustment handle is set at ______ for a 90 degree cut UNLESS you need a miter cut.
What is zero?
The _____________must be removed on the table saw before making a through dado cut on your board.
What is safety guard?