Ball valve
Which piece of equipment has the highest estimated flow to the RTO?
Nutsches
What precent caustic is used in caustic scrubbers?
20%
This type of valve will allow fluid to flow in only one direction
The purpose of this piece of equipment is to add a liquid or solution to a reactor at a specific rate
Weight Tank
A pipe with several opening for making multiple connections is?
Manifold
This procedure states specific step-by-step rules for operating the equipment located in the manufacturing area
EOP
What system do we have that when used will block the flow of material being transferred into the building in case of a leak, fire or other emergency condition?
Emergency Cut-off valve
High Level Sensor
Why is make-up water added to a scrubber system?
A. To flush the scrubber out
B. To maintain an overflow
C. To knock down more impurities
B. To maintain an overflow
This type of purge requires pressurizing the vessel and venting 3 times
Pressure
This piece of equipment is suspended from the ceiling on the load cells
What is the 2nd stage of a two-stage scrubber system?
Caustic Scrubber
A safety mechanism that consist of a series of locks that must be operated that prevents entry in the dryer cage while the dryer is rotating
Kirk-Key Interlock
Name 2 things to check if the dryer will not pass the leak check
The gasket, dropout valve open, etc.
A metal cage that sits on the end of the vacuum leg that can have a cotton or dacron cloth on it
Dryer sock cage
What does VOC stand for?
Volatile Organic Compound
This is located inside the dryer and has a sock cage on the end of it and is connected to a vacuum source
Vacuum Leg
This equipment is used to remove volatile from the solid material by evaporating the more volatile material away
Dryer
What is the largest source of air flow going to the RTO
Nutsches
This is placed over the nutsche boards, is made from plastic with large opening holes
Vexar Screen
What line is used to heat the tempered water for circulation through the jacket?
What are the two most important parts of the steam ejector?
Nozzle and Venturi
Where is the cloth located on a centrifuge
Behind the screen
What is the difference between a single stage and three stage jet system?
Amount of ejectors and condensers