Pump
How do you fingerprint an IXM pump?
Once when you default, once when you config with max speed, once when you reduced speed
What are all the LOTO Points?
Gas, N2, O2, CDA, Power, Bypass manual iso valve, Green button
Whats the first paperwork you should verify before work?
The PPE matrix, comparing that to the WO
GV button in HMI is greyed out, why and how to fix this issue.
communication between the pump and PGV needs to be set, use PDT to cycle the GV to set the communication.
Freebee
yippee
Whats the IP address on an IH pump?
None, no synergis
What are the 2 ways to purge an abatement?
System Purge, and then the long way
How do you know if your tool is a dragon tool, and whats the PPE requirement?
Full acid suits, and respirator even during wet side
after installing a New pump, the pump is saying "Pump inverter is too hot"
Bad pump, replace
Whats my favorite cuisine of food?
Japanese
How do you do an exhaust pressure zero?
What are the 3 ways used to adjust RO? 2 are valves, one is a setting
Butterfly valve, premix fan set screw, and premix fan screw
How do you know what kind of orings to use?
Specialty Oring spec
How do set up 50 If Stop on a pump that didnt have one?
Set the N2 regulator to 50, and then install the config
Which ones better? Shower Sprite, Shower Dr. Pepper, Shower Beer, or Shower Whiteclaw
Shower sprite
CDT and AVX are both reactive. How are both reactive
When does a 2 position valve high flow activate? In other words, what other function is it tied to?
Head clean?
How do you setup an abatement for RO?
Make sure atomizer is turned off, N2 Purges are off, bypass's dont roll because abatement is in HMI mode, head purges are capped off, CDA is off, all capped inlet lines are capped.
Do the return on stores, write in the comments: "Hold for FOI" and do the same for the EcUDL, then send the email and tell amber
What is the best reptile for swinging over your head like a bola, then throwing?
Iguana
Explain how to do leak checks from pump to abatement (high detail)
Yea
How much should you fill the packed tower with media?
300mm below the packed tower spray lance, or 12 inches. Mr beef
When should you use SPM flex's?
Dragon or EDT tools
What are some reasons (At least 5) your brand new pump isnt basing down
Yes
Jose VS Giraffe, who would win
Jose obviously