Tool Identification
Material Identification
Circuitry Calculations
Electrical Theory
Electrical Safety
NEC
100
The official name for this tool, commonly referred to as linesman pliers
What are side cutting pliers?
100
This item is used in most conduit runs. Its makes for a good splice point. 
What is a four square junction box?
100
Calculate the voltage drop over an 8 ohm resistor, if the circuit is pulling 6 amps.
What is 48 volts?
100
The force that causes electrons to flow in a circuit.
What is voltage?
100
What does "PPE" stand for?
What is personal protective equipment?
100
The organization that writes the National Electrical Code.
What is the National Fire Protection Association?
200
What is the official name for this tool?
What are diagonal cutting pliers?
200
You'll spend a lot of time installing this specific device.
What is a duplex receptacle?
200
Calculate the voltage of series circuit pulling 20 amps and having a resistance of 6 ohms.
What is 120 volts?
200
The rate at which electrical work is done when one ampere of current flows through one volt
What is a watt?
200
What does GFCI stand for?
What is Ground Fault Circuit Interrupter?
200
This article of the NEC covers definitions?
What is Article 100?
300
The name of this tool, which is commly used to make holes in concrete or brick.
What is a hammer drill?
300
This item is good for mounting conduit to walls.
What is a one hole strap?
300
Calculate the wattage of series circuit pulling 3 amps and having a resistance of 4 ohms
What is 36 watts?
300
The opposing force to current in a circuit
What is resistance?
300
What does LOTO stand for?
What is Lock out, Tag out?
300
In the NEC what does "AHJ" stand for?
What is the Authority Having Jurisdiction?
400
Use this tool to mark the center of light over the floor.
What is a plumb bob?
400
This item is good for supporting multiple conduit runs.
What is Unistrut?
400
A series circuit has 3 resistors measured at 7 ohms, 11 ohms, and 9 ohms. What is the circuits total resistance?
What is 27 ohms?
400
The flow of electrons in a circuit
What is current?
400
What should you do before working on any circuit?
What is make sure the circuit is de-energized?
400
What does article 250 of the NEC cover?
What is Grounding and Bonding?
500
What is the official name of this tool? 
What is an adjustable wrench
500
Name this conduit body.
What is a C?
500
Calculate the total resistance of a parallel circuit with one branch having a resistance of 4 ohms and the other having a resistance of 12 ohms
What is 3 ohms?
500
The main difference between electron flow theory and conventional flow theory.
What is electron flow theory is negative to positive whereas conventional flow theory is positive to negative?
500
What year did the President sign the Occupational Safety and Health Act?
What was 1970?
500
The circuit conductors between the final over-current device protecting the circuit and the outlet
What is branch circuit?