What tool is used to check whether something is level?
A level
What is the most common type of residential roofing material in America?
Asphalt shingles
What tool is used to drive nails into wood quickly?
Nail gun
What is the process of applying joint compound to drywall seams called?
Taping and finishing
What does GFCI stand for?
Ground-Fault Circuit Interrupter
What does PSI stand for?
Pounds per Square Inch
What is the material installed beneath shingles to provide an additional layer of protection?
Roofing underlayment
What tool is used to cut wood at precise angles?
Miter saw
What material is commonly installed behind certain tile installations in wet areas?
A suitable tile backer board or approved waterproofing system.
What is the main purpose of a P-trap under a sink?
To hold water that prevents sewer gases from entering the home.
What is the standard thickness of residential drywall commonly used on walls?
1/2 Inch
What is flashing used for on a roof?
To prevent water intrusion around roof penetrations and transitions.
What tool is used to find studs behind drywall?
Stud finder
What is grout used for?
Filling the joints between tiles.
What does a circuit breaker do?
Interrupts electrical power when a circuit experiences an overload or short circuit.
What is the triangular framework that supports a roof called?
A roof truss
What does roof pitch describe?
The steepness or slope of a roof.
What is a chalk line used for?
Marking straight reference lines over long distances.
What does "square footage" measure?
The area of a surface, calculated by multiplying length by width.
What is the difference between a supply line and a drain line?
A supply line brings water into a fixture; a drain line carries wastewater away.
What is the difference between a load-bearing wall and a non-load-bearing wall?
A load-bearing wall supports structural weight; a non-load-bearing wall does not.
What is the difference between roof decking and roof underlayment?
Decking is the structural surface attached to the roof framing; underlayment is the protective layer installed over the decking.
What is the difference between a circular saw and a miter saw?
A circular saw is handheld and versatile; a miter saw is stationary and designed for accurate crosscuts and angled cuts.
What is the purpose of a vapor retarder in certain wall assemblies?
To control water vapor movement through the building assembly and reduce condensation risk.
What is the purpose of a plumbing vent stack?
To allow air into the drainage system and help maintain proper drainage and trap seals.