H&P
How many gallons of oil does the Engines take?
89 gals
What are the three steps of an LMRA?
STOP to recognize risks
THINK of ways to control the risks
ACT to perform the work safely
What type of drilling conditions can make kick detection more difficult for the driller
Drilling low permeability formation with oilbased
fluids
How does increasing pressure affect non-aqueous (oil-based) mud density
Increases density
Show me the formula for bottoms up in bbls.
ID2 - OD2 / 1029.4 x Depth= BBLS
Whats the capacity for oil the air compressor?
2 Gallons
What is the focus of PSMS?
To eliminate Life Altering Injury.
What causes gas to break out of solution in an Oil Based Mud (OBM
The decrease in hydrostatic pressure above the gas when it gets close to surface
How does increasing wellbore temperature affect well control when using non-aqueous (oil-based) mud?
Decreases hydrostatic pressure in wellbore
Show me the formula for getting Pump Output.
(Liner size)2 x (stroke length)2 x (.000243) X.95= output
Gear oil Capacity on TDS
15 gallons
What is our Target Area?
Line Of Fire
While preparing to circulate Kill Weight Mud, the gas bubble begins to migrate. If no action is taken, what will happen to bottom hole pressure?
Increase
The formation permeability, and the differential pressure between mud hydrostatic and formation pressure, will affect the speed of the influx into the well. Which of the conditions below are likely to give the largest influx over the same period of time?
High permeability formation with a high differential pressure
Testing to MW - current MW x TVD x 0.052
Hydraulic oil capacity on tds
25 gallons
Once a trigger is observed what two steps must you take?
1) Stop Work
2) Use LMRA to evaluate and mitigate the hazard
What will influence the test pressure recorded during a leak-off test?
Mud density in the well
Why must you leave spare capacity in the active pit system when circulating out a kick?
If the kick is gas it will expand and pit level
will increase.
show me the formula for finding out kill mud weight.
(SIDPP, psi ÷ .052 ÷ TVD, ft) + Mud Wt, ppg
gear oil capacity on mud pumps
85 gals
What is AAR? What are the 4 Questions?
AAR- After Action Review: brief learning process conducted immediately after completing LAI potential task or critical action.
1.What was supposed to happen?
2.What actually happened?
3.What were the differences?
4.What can we learn?
After pulling 33 stands, the well starts flowing and is shut-in. Assume that the influx is at the bottom of the hole and there is no gas migrations. What will happen to casing pressure as the drill string is stripped into the influx?
Increase
What Is The PSI Rating For The Rotate Head?
Dynamic and Static?
3000 static
1500 dynamic
MAASP is the maximum allowable annular surface pressure what is the formula you would use?
(Frac. M. Wt, ppg – Current M.Wt, ppg) x .052 x Shoe TVD, ft